Electro Magnetic Interference (EMI) is a natural byproduct of all aviation anti-collision strobe systems, both old and new. It is created and radiated when strobe systems suddenly turn electricity into light pulses, and sometimes can be detected in intercoms and communication radios as audio noise every time the strobes activate.
Aveo Engineering designs and builds extremely quiet LED strobe systems, as evidenced by our beacons and wingtip units. So much so that Aveo products are widely used in military UAVs, where low EMI is an absolute requirement. Anything that could interfere with operational telemetry is simply not tolerated.
In aviation, there is no such thing as good EMI, no matter how small. Aveo has taken the extra step to create the Spike-D series of in line EMI filters. These small, inexpensive units are extremely effective in greatly attenuating residual EMI found in avionics installations.
These spectrum analyzer photos below, show just effective the Spike-D filters are. (Frequency range depicted is 300kHz – 2MHz, which corresponds to DO-160 Chapter 21, Emission of Radio Frequency Energy.)
The yellow traces depict normal radio frequency background noise.
The blue traces depict EMI without Spike-D.
The red traces depict EMI with Spike-D.
Ultra Embedded
RedBaron XP red
EXAMPLE OF USE – Over Voltage Protection
With input voltage below 7.2 and above 44.5 Spike-D output is disconnected from input. With negative polarity Spike-D output is disconnected from input.
- Filtration DO-160G, chapter 21, Emission of Radio Frequency Energy: More than 10dB; - Output current, not less than: Steady: 4A per channel; Pulse 1/3: 5A per channel; - Output power, not less than: Steady: 4A at 9..36VDC per channel; Pulse 1/3: 5A at 9..36VDC per channel; - Input power, not more than: Steady: 4A at 9..36VDC per channel; Pulse 1/3: 5A at 9..36VDC per channel; Warm up time: 0.5sec Ambient temperature: -40°C..+85°C Overheat protection: +85°C
Wiring:
a. wire type: FEP High Temperature teflon wire, 20 AWG b. wire length: min. 10 inch (280mm) Wire color code: 1. Input, power supply side: a. 20AWG Green +9…36V, first channel input b. 20AWG Orange +9...36V, second channel input c. 20AWG Black Common return VRTN to power supply for first and second channel 2. Output, light side: a. 20AWG Red +9…36V, first channel output b. 20AWG Yellow +9…36V, second channel output c. 20AWG Black GND light Please, do not connect black wires from input and output together.
Video
Reviews (0)
Напишите ваш собственный отзыв
Only registered users can write reviews. Please, log in or register
This website requires cookies to provide all of its features. For more information on what data is contained in the cookies, please see our Privacy Policy page. To accept cookies from this site, please click the Allow button below.